www.zeroshell.org Forum Index www.zeroshell.org
Linux Distribution for server and embedded devices
 
 SearchSearch  RegisterRegister  UsergroupsUsergroups 
 ProfileProfile  Log inLog in  Log in to check your private messagesPrivate Message 

Load Balancing and Banking

 
Post new topic   Reply to topic    www.zeroshell.org Forum Index -> ZeroShell
View previous topic :: View next topic  
Author Message
Atriasys



Joined: 23 Jul 2014
Posts: 3

PostPosted: Wed Jul 23, 2014 8:29 am    Post subject: Load Balancing and Banking Reply with quote

Hi there,

I have been using Zeroshell (in a VMware machine) since version 2 - I originally got it to provide my customer with load balancing across their 3 internet connections. However I quickly found out that the users could not access banking or other sites that used security - I guess because they try to send a response to the originating IP address.

I have upgraded to version 3.0 and I still have the same problem.

Can someone please assist me with setting up the balancing rules so the banking sites work?

I have previously tried setting a rule for port 443 to go through only 1 connection - but that didn't work for some reason.

eg:
MARK tcp opt -- in * out * 0.0.0.0/0 -> 0.0.0.0/0 tcp dpt:443 MARK set 0x66
Back to top
View user's profile Send private message
redfive



Joined: 27 Aug 2009
Posts: 232

PostPosted: Wed Jul 23, 2014 10:59 am    Post subject: Reply with quote

Are you using also the proxy, in addition to the load balancing ?
Regards
Back to top
View user's profile Send private message
Atriasys



Joined: 23 Jul 2014
Posts: 3

PostPosted: Wed Jul 23, 2014 4:44 pm    Post subject: Reply with quote

Hi there,

In my example above - no I wasn't using the proxy - however my customer wants now to also block access to certain sites and I understand the proxy is the way to do this - so I will be turning it on.
Back to top
View user's profile Send private message
Atriasys



Joined: 23 Jul 2014
Posts: 3

PostPosted: Thu Jul 31, 2014 10:36 pm    Post subject: Reply with quote

Can anyone assist me with this please?

I have turned on NAT for the interface (Only 1 interface used ETH0)

When I turn on any more than 1 connection to active - users lose all ability to access the Web.

I must be doing something wrong - I just can't figure it out - I will post a network diagram also.


[IMG]http://i.imgur.com/KxJrbfP.jpg?1[/IMG]
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic    www.zeroshell.org Forum Index -> ZeroShell All times are GMT
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group