| View previous topic :: View next topic |
| Author |
Message |
Madwin
Joined: 09 Oct 2008
Posts: 6
|
 Posted: Thu Oct 09, 2008 3:43 pm Post subject: Captive Portal not using a Domain |
 |
|
Hi
i would like to know if there's a way to use the Captive Portal without attaching or using a domain to authenticate, I have a lab setup with an AP just for it, and it works fine, but I would like to not use the domain to authenticate, i'd appreciate any help you guys can give on this issue, thanks
best regards |
|
| Back to top |
|
 |
fulvio
Site Admin
Joined: 01 Nov 2006
Posts: 997
|
| Posted: Thu Oct 09, 2008 9:13 pm Post subject: |
|
|
It is not possible to authenticate without specify a domain. In the one of the next releases the domain combobox in the weblogin page will be hidden if there is only one defined authentication domain.
Regards
Fulvio |
|
| Back to top |
|
|
Madwin
Joined: 09 Oct 2008
Posts: 6
|
| Posted: Tue Oct 14, 2008 7:49 pm Post subject: |
|
|
Thanks for the response fulvio
one other thing, in the Setup-->Network Menu, both my interfaces are Half Duplex, is there a way i can set them up to Full Duplex through the web interface or the linux shell? I tried doing it like this:
| Code: | | ethtool -s ETH00 autoneg off duplex full |
but it didn't work, is there a way i can do it?
Best Regards |
|
| Back to top |
|
|
Madwin
Joined: 09 Oct 2008
Posts: 6
|
| Posted: Tue Oct 14, 2008 8:49 pm Post subject: |
|
|
fulvio, i tested again the command for the Full Duplex and it works, but i want to know if there is a way I can set it up so it can start at Full Duplex once the server reboots.
Best Regards |
|
| Back to top |
|
|
|
Search
Register
Usergroups
Profile
Log in
Private Message
