www.zeroshell.org

[esvabas]

Hi,

I have Intel Corporation 82546EB Gigabit Ethernet Controller WAN and LAN ports on them.
Also it has 3rd port, just for management. management port works fine which is Intel Corporation 82541EI Gigabit Ethernet Controller .
Basically the network card works in bypass mode, I get no link lights on them, but it passes traffic even if the server is off.
Any way to trigger with zeroshell to take those ports out of bypass?

ZeroShell says:

ETH00 No link detected
Intel Corporation 82546EB Gigabit Ethernet Controller (Copper) (rev 01)
ETH01 No link detected
Intel Corporation 82546EB Gigabit Ethernet Controller (Copper) (rev 01)

So because of that, it is not doing any filtering etc.,