› Forums › Network Management › Networking › Confused on how to setup WAN interface as a gateway › Reply To: Confused on how to setup WAN interface as a gateway
May 4, 2016 at 12:26 pm
#54137
Member
Hi.
I’m not sure how ZeroShell behaves as DHCP client on the WAN interface.
But where is the problem to configure the WAN interface with fixed IPs? I would prefer fixed IPs.
This way you would set the default gateway address by pressing the button “gateway” on “SETUP”->”Network”.
Depending on the configuration of your WAN, it might be necessary to activate NAT for the WAN interface by pressing the button “NAT” and then adding the WAN interface.