3.0.0 changed ip – how to access web gui

› Forums › Network Management › ZeroShell › 3.0.0 changed ip – how to access web gui

  • This topic is empty.
Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • January 21, 2014 at 6:51 pm #43825
    pp
    Member

    Hi,

    I’ve just installed 3.0.0 in a remote location (only KVM access).
    So I’ve to change the IP address of the zeroshell box, everything is working network wise but I can’t connect to the web gui.
    Entering Fail-Safe Mode enables it possible (until the next reboot)…

    Is there any firewall rule forcing this behaviour? Any idea how can change this?

    Thanks!

    January 21, 2014 at 8:52 pm #53109
    DrmCa
    Participant

    Do you mean it starts up with default IP for LAN interface and that address is not within the block used by the LAN? Then I guess you’ll have to configure IP using local keyboard/monitor.

    January 21, 2014 at 9:28 pm #53110
    redfive
    Participant

    Maybe I’m wrong , with the previous releases , the management was allowed , with default config, from any interface and any ip address…but seems that starting from 3.0.0 release , the management is allowed only from private address space. Take a look in SYSTEM>>Setup>>Web.
    greetings

    January 22, 2014 at 8:21 am #53111
    pp
    Member

    @redfive: Thank you, this fixed it!
    Next task: try weighted bonding! 🙂

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.