Allowing access to web UI from public IP (via ssh)

› Forums › Network Management › ZeroShell › Allowing access to web UI from public IP (via ssh)

  • This topic is empty.
Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • December 26, 2015 at 9:21 am #44470
    mob
    Member

    Hello and thanks for reading -and hopefully responding to- my post

    After a fresh zeroshell install on a vps in a datacenter, i’m unable to access the web interface from my public IP to complete the configuration, web access is automatically configured to private subnets only.. What are the required commands that I can run over ssh to enable web access from my public ip?

    December 26, 2015 at 10:29 am #53992
    redfive
    Participant
    iptables -I SYS_HTTPS -j ACCEPT

    You should be able to access the web interface, then adjust the settings as per your needed via gui (the above rule will be cleared as soon as you save the new settings via gui).
    Regards

    December 28, 2015 at 4:39 pm #53993
    mob
    Member

    Thank you very much!

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.