Blocking GUI access

› Forums › Network Management › ZeroShell › Blocking GUI access

  • This topic is empty.
Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • August 19, 2008 at 12:34 am #41145
    Frothingdog
    Member

    I work for a Wireless ISP and I just started tinking with ZS and I’m likeing it alot. Got it installed on a Soekris 5501.

    We will be using these at all our Tower locations to do routing and QoS.
    After playing around a bit and getting DCHP enabled on one of the interfaces, I realized that I need to block access to the decive so the DHCP clients can not access it. Is there a way to block access to the GUI on one interface but allow it on another?

    Example:
    ETH0 – UP Stream – Needs Gui Access
    ETH1 – DHCP to clients – Block Access to GUI

    Thanks

    August 19, 2008 at 12:37 am #46786
    sugarfree
    Member

    log into the GUI, select “Setup” from the left menu the “https”. from there you can choose which adapters can access it and even limit it to certain IPs.

    August 19, 2008 at 12:45 am #46787
    Frothingdog
    Member

    WOW…guess I should have played around with it alittle more before asking. Didn’t think it would be that simple.

    Thanks

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.