Bridge With 2 Nics (Fail Open) fault tolerant.

› Forums › Network Management › Bridges and Routers › Bridge With 2 Nics (Fail Open) fault tolerant.

  • This topic is empty.
Viewing 1 post (of 1 total)
  • Author
    Posts
  • November 23, 2013 at 8:41 pm #43790
    cafecraft
    Member

    hello,

    appliance have a Dell Power Edge R200 with 4 NIC interfaces fail open, the Zeroshell recognizes them with module e1000e. I’m with this scenario below:

    • Loss of power
    • Hardware failure (HDD, MB)
    • Software crashes or panics, no need change cables in switch.

    I could not do Zeroshell manage these plates (Fail Closed), the plates are doing bypass the hadware own (bridge in hardware)

  • Author
    Posts
Viewing 1 post (of 1 total)
  • You must be logged in to reply to this topic.