Config of Contivity 1100

› Forums › Network Management › ZeroShell › Config of Contivity 1100

  • This topic is empty.
Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • November 3, 2017 at 8:19 pm #44893
    econst
    Member

    Hi All,

    First post here. Have a Nortel Contivity 1100 device that I have installed ZS 3.7.1 on. This device is basically a Pentium3 board with 4 LAN ports and 1 WAN port. It has 2 PCI slots to add additional modules/cards. I have read that others have used this device to install MonoWall.

    Once the device boots, I can use the serial console to run the command that comes up. If I issue the command “lspci”, I can see the Ethernet cards. I however can not access the GUI at the default IP address. Has anyone tried this device.

    November 4, 2017 at 4:38 am #54620
    econst
    Member

    I noted that on the connection status of my network port on my notebook, there is no received packets. My port is ok. I have tried several options to try to get the port to work, but to no avail. Anyone has an idea?

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.