Connect using multiple IP and balancing

› Forums › Network Management › ZeroShell › Connect using multiple IP and balancing

  • This topic is empty.
Viewing 1 post (of 1 total)
  • Author
    Posts
  • February 27, 2013 at 1:02 pm #43588
    rig
    Member

    How can I connect my ZeroShell to a router using multiple IP?

    Can I then setup the Weight for each IP in NetBalancer?

    I read that BOND allow to use multiple connections, can I Add IP to ETH1 (for WAN) and BOND them in “Fault Tolerance and Load Balancing”?
    ..or is this a heresy? ..because I tried and didn’t work..

  • Author
    Posts
Viewing 1 post (of 1 total)
  • You must be logged in to reply to this topic.