dedicated line & failover

› Forums › Network Management › ZeroShell › dedicated line & failover

  • This topic is empty.
Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • October 22, 2009 at 8:13 am #41991
    space007
    Member

    Hi All,

    I am new to the ZeroShell, so need to inquire a bit.

    I plan to put ZeroShell between local and two dedicated lines to 1 external lan site.
    I dont want to load balance, the traffic should go using line 1 when available, if that connection goes down for any reason, automatically use the second line.

    is this possible?

    regards,
    Biagio

    October 22, 2009 at 1:05 pm #48965
    ppalias
    Member

    Yes, you can use the Failover only Mode of the Netbalncer, not the “Load Balancing and Failover”

    October 22, 2009 at 1:54 pm #48966
    space007
    Member

    @ppalias wrote:

    Yes, you can use the Failover only Mode of the Netbalncer, not the “Load Balancing and Failover”

    my fault, did not look into it fully 🙁
    found it.

    grazie
    biagio

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.