Failover Balancer mode return to Balancer mode after reboot. › Forums › Network Management › Signal a BUG › Failover Balancer mode return to Balancer mode after reboot. This topic is empty. Viewing 2 posts - 1 through 2 (of 2 total) Author Posts March 30, 2009 at 8:29 am #41596 olivier1010Member The failover mode seems to not stay after a reboot. Need to change it to balancing, save and failover again, save to get it in the right mode. Sometimes as well, the active / spare interface is reversed. Come back to normal after a new failover / balancing switch in the gui. October 27, 2015 at 9:03 am #47919 BurnerParticipant @olivier1010 wrote: The failover mode seems to not stay after a reboot. Need to change it to balancing, save and failover again, save to get it in the right mode. Sometimes as well, the active / spare interface is reversed. Come back to normal after a new failover / balancing switch in the gui. Bump I can confirm this behaviour. Zeroshell Release 3.3.2 Failover usually works very well, but it fail to set up routes correctly on boot. Author Posts Viewing 2 posts - 1 through 2 (of 2 total) You must be logged in to reply to this topic. Log In Username: Password: Keep me signed in Log In