Inserting ZS into current LAN (Bridging mode)

› Forums › Network Management › Bridges and Routers › Inserting ZS into current LAN (Bridging mode)

  • This topic is empty.
Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • September 30, 2013 at 11:12 am #43744
    MadX
    Member

    We have a LAN running here, and I want to put in a transparent firewall.

    After setting up the bridge (BRIDGE00), I added an IP to the bridge interface ..

    Now, from either side of the bridge, I can ping the bridge IP, but I cannot ping either side of the box.
    What should I be adding to allow the machines to “see” each other.

    There are no VLAN tags, and it is a straight Class C network ..

    EDIT:

    ETH00 and ETH01 are added to BRIDGE00

    February 5, 2015 at 2:10 pm #52914
    maccowley
    Member

    Did you turn DHCP and NAT off?
    Normally a bridge is very simpel to setup.

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.