LAN-TO-LAN sample configuration

› Forums › Network Management › VPN › LAN-TO-LAN sample configuration

  • This topic is empty.
Viewing 1 post (of 1 total)
  • Author
    Posts
  • December 28, 2011 at 3:39 pm #43222
    marius_roma
    Member

    I am attempting to setup a LAN-TO-LAN configuration in a lab area.
    I see the two ZeroShell hosts connect and the tunnel, but I am unable to make hosts on both LANs see each others.
    After reading the documentation and posts I found I am quite sure I missed some relevant configuration step.
    Is there anywhere a complete sample configuration, including *all* the required settings and, maybe, a sample of IP addresses?
    Regards
    marius

  • Author
    Posts
Viewing 1 post (of 1 total)
  • You must be logged in to reply to this topic.