setting up a routing server

[Alexandru Bumbacea]

when i can find some tutorials for setting up zeroshell? i am trying to set the server as a gateway, but i can not make its conn to the inet.
eth00 is to the local-network, and i can access it at 192.168.0.75
tho01 is to inet and i put 12.12.12.12(12 is a random values) and subnet 255.255.255.0, i also set the gateway to 12.12.12.254

PING 12.12.12.254 (12.12.12.254) 56(84) bytes of data.

From 12.12.12.12 icmp_seq=2 Destination Host Unreachable

From 12.12.12.12 icmp_seq=3 Destination Host Unreachable

How do i set it up corectly?

[imported_fulvio]

I think you have to enable the NAT on the ETH01 interface because 192.168.0.0/24 are private IP addresses.

Regards
Fulvio

[Alexandru Bumbacea]

even if a give ping from the server? from console?

[imported_fulvio]

No, from the console you don’t need to enable the NAT.
Have you tried to replace the network interfaces and the cables?

Regards
Fulvio

[Alexandru Bumbacea]

finally i succeded….
can i configure it as a vpn server? for outside connections?

[imported_fulvio]

Yes, of course you can. You can enable Zeroshell for the L2TP/IPSec host to LAN VPN.

Regards
Fulvio

[Alexandru Bumbacea]

I would like to install it on a VM:
I have next conf:

1 Sitecom router with port forwording(192.168.12.0/24 for internal use)
main comp:P4(2,66GHz, 1GBRAM, 1net adap)
Zeroshell Vm:(128RAM, 2 network addapters(bridged))

port forwording is set for Eth00 on zeroshell .
Is that Ok?

[Author]

Posts