chrisbarr35

Forum Replies Created

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • in reply to: VPN Bonding speed issue #49341
    chrisbarr35
    Member

    Hi PP,

    sorry for the delay in replying. I’ve tried again today using a physical server rather than a VM at the datacentre side but with the same results.

    Here is a screenshot of the configuration when both Tunnels are UDP. note how on this second tunnel the remote host IP is different to the IP it has actually connected to.

    Have problems with Bonded VPN performance every been resolved?

    thanks again

    chris

    in reply to: VPN Bonding speed issue #49339
    chrisbarr35
    Member

    Hi PP,

    I read that post the other day and tried the UDP VPN tunnels, however both tunnels connected using the IP listed in the first tunnel configuration and sent all traffic down the first link.

    Is there a way to avoid this?

    regards,

    in reply to: VPN Bonding speed issue #49337
    chrisbarr35
    Member

    Hi PP,

    I’ve tried the connections over UDP as well however the zeroshell device connects both tunnels to the IP of the first tunnel and then the “bonded” speed is only the speed of a single connection because only the first is used.

    I’ve tested both connections and get roughly 5Mb/s down and 0.6Mb/s upload on each. When using the VPN bond I get 1.5Mb/s down and 1Mb/s on the upload. The bond is working perfectly on the upload but not on the download!

    I’ve had a look at all the other posts of similar issues but there doesn’t seem to be a solution found yet.

    thanks

    Chris

Viewing 3 posts - 1 through 3 (of 3 total)