Forum Replies Created
November 4, 2008 at 1:04 am in reply to: Zeroshell With Alix6B2 and Sierra Wireless MC8780 3G HSDPA #47085lyndenMember
When I created the 3G modem, the file ppp0.3G was created. The contents are in the section below. The log file at the bottom shows the connection attempts failing before the change to this file. The connection succeeded immediately on the next attempt after changing the file.
I have change the username and password used in this email for obvious reasons. It would be great if the username and password parameters could be added to the 3G setup page.
10:51:01 Serial connection established.
10:51:01 Using interface ppp0
10:51:01 Connect: ppp0 /udev/ttyUSB2
10:51:34 IPCP: timeout sending Config-Requests
10:51:40 Connection terminated.
10:51:40 Modem hangup
10:51:49 pppd 2.4.3 started by root, uid 0
10:51:51 Serial connection established.
10:51:51 Using interface ppp0
10:51:51 Connect: ppp0 /udev/ttyUSB2
10:52:24 IPCP: timeout sending Config-Requests
10:52:30 Connection terminated.
10:52:30 Modem hangup
10:52:40 pppd 2.4.3 started by root, uid 0
10:52:41 Serial connection established.
10:52:41 Using interface ppp0
10:52:41 Connect: ppp0 /udev/ttyUSB2
10:53:13 IPCP: timeout sending Config-Requests
10:53:19 Connection terminated.
10:53:19 Modem hangup
10:53:30 pppd 2.4.3 started by root, uid 0
10:53:32 Serial connection established.
10:53:32 Using interface ppp0
10:53:32 Connect: ppp0 /udev/ttyUSB2
10:53:33 CHAP authentication succeeded
10:53:36 Could not determine remote IP address: defaulting to 10.64.64.64
10:53:36 local IP address 10.97.163.198
10:53:36 remote IP address 10.64.64.64
November 2, 2008 at 9:39 pm in reply to: Zeroshell With Alix6B2 and Sierra Wireless MC8780 3G HSDPA #47083lyndenMember
When I created the 3G interface, a file ppp0.3G was created in the /tmp directory. If I add user XXX and password YYY to this file with the correct username and password and restart the service it connects. How can I make this change permanent?